- Python 70.4%
- C++ 24.5%
- JavaScript 5.1%
|
|
||
|---|---|---|
| case | ||
| docs | ||
| fw | ||
| pcb | ||
| README.md | ||
| volumeslider.FCStd | ||
volumeslider
Motorised volume slider with an ESP32-S3
| Top | Bottom |
|---|---|
![]() |
![]() |
Case
| Exploded | Lid removed |
|---|---|
![]() |
![]() |
The case hangs on the wall: the tray slides down onto a dovetail rail on the backplate, which has the same outline as the case. Print the tray in translucent material; the LEDs on the bottom of the PCB light it through its thin side walls. The lid, two T-shaped button plungers and two hex-mesh vent panels (over the CO2 sensor and microphone) print flat. The vent panels and buttons are captured between tray and lid; four M3 screws from the back thread into the lid (M3x20 at the USB end, M3x16 at the other).
case/build_case.py builds every part from the board's STEP export, checks them for collisions and print overhangs,
and writes the STLs, volumeslider-case.step and an interactive viewer (case.html).
case/render.py renders the images above. Run both with FreeCAD's freecadcmd.
Building without LEDs
If the RGB LEDs are not needed, the 5 V buck can be unpopulated and the solder jumper can be bridged. This feeds the 3.3 V regulator straight from the 9 V USB-PD rail.
Contents
pcb/– KiCad project (schematic, board, project libraries) andvolumeslider-bom.csvfw/– ESPHome firmware (volumeslider.yaml, fader controller infader.h, web UI slider infader-ui.js)case/– parametric case (FreeCAD script, STL/STEP exports)volumeslider.FCStd– FreeCAD model




